Watanya is ready to supply and install all types of (Diesel – Gas – Dual) with all capabilities also we can implement the board that is used to operate burner and the safety units of boiler with spare parts made in European Community. We can also make a full maintenance to burner while all spare parts that is needed for burner are available. All works are performed by specialized engineers.Steps to start the burner:Do those steps and sequencing automatic controllers (Control Box) and of the most famous products of SIEMENS and Honeywell and Fireye. And the primary purpose of these steps observe start burner and control flame levels during playback and control off the burner and the following simple explanation for these steps
the program runs the burner engine in High Fire position but without opening the fuel valves where clearance is done to the boiler’s fire House for a limited period of time.after completion of the cleansing cycle, the program converts status to Fire Low. start a Pilot valve with open spark trans. in the case of a continuing and steady flame demo program to move to the next step if uncorroborated program Pilot valve closed and shut down Terrence spark and send a signal to turn alarms In case experimental flame is stable,the program starts after a certain period the main fuel valve turned on Low minimum rate of Fireafter a certain time period other program starts increasing the flame until the maximum High Firewhen you reach the desired temperature or pressure The program converts the flame again of High Fire to Low Fire and then to full closure and begin these steps again when running again.
©All Rights Reserved. 2020. WATANYA design and development BY Engazmedia